ALS maintenance classroom (6) Replace nozzle

After the nozzle is replaced, it needs to be coaxially calibrated. Coaxiality directly affects the cutting quality. Poor coaxiality will cause one side to be cut well and the other side to be cut badly when cutting the iron plate.

Aug 18,2023

ALS maintenance classroom (5) Replace ceramic ring

Precautions: After replacing the ceramic ring, it needs to be coaxially calibrated. The coaxiality directly affects the cutting quality. Poor coaxiality will cause one side to be cut well and the other side to be cut badly when cutting the iron plate. That is to say, the laser beam and gas, the laser beam need to be shot from the middle of the nozzle.

Aug 12,2023

ALS maintenance classroom (4) Replace the lower protective lens

Before replacing the protective lens, we should turn off all fans and fans, try to create a wind-free and dust-free environment, and remember to wash hands (if conditions permit, please operate in a dust-free box)

Aug 07,2023

ALS maintenance classroom (3) Replace Upper protective lens

Before replacing the protective lens, we should turn off all fans and fans, try to create a wind-free and dust-free environment, and remember to wash hands (if conditions permit, please operate in a dust-free box).

Jul 28,2023

ALS Maintenance Classroom (2) | Replacing Collimators

Remove the cover plate of the collimator first, loosen the screws one by one in a diagonal way, and keep the stress on each corner uniform without damaging the bolts

Jul 21,2023

​​​​​​​ALS Maintenance Classroom | Replacing the Focusing Glass

Remove the cover plate of the focusing lens. The screws are coated. Please place them separately

Jul 14,2023

绿色激光光学镜片的材料用途和原理

亚克力具有重量轻、价格低、易成型等优点。其成型方法包括铸造、注射成型、机械加工、亚克力热成型等。

Feb 04,2023

安装紫外激光器光学镜片的注意事项有哪些

用肥皂或洗涤剂清洁双手,并戴上轻便干净的白手套;严禁用手的任何部位接触紫外激光器镜片;取紫外激光器镜片时,要从镜片的侧面取,不要直接接触紫外 激光器镜片的镀膜表面。

Feb 04,2023

如何清洗绿色激光器的镜片

不同的绿色激光光学镜头有不同的清洁方法。当镜面为平面且无镜座时,用镜头纸进行清洁,如:清洁保护镜;当镜面为弧形或有镜座时,用棉签进行清洁。

Feb 04,2023

紫外激光光学镜片的加工流程

紫外激光光学镜片加工过程中,从光学玻璃厂送来的镜片表面仍然是磨砂的,有凸起的形状,最终抛光后的镜片晶莹剔透,外观漂亮。加工的流程是首先进行抛光,将镜片表面的微小不平整处磨平,然后用含金刚石的树脂进行粗磨,最后用磨具进行精磨。

Feb 04,2023

< 1 > proceed page